The reverse error detection method of the linear motion of the machining center.

Author: MULAN -Plastic Molding Manufacturer

The opinions of the cnc machining center are as follows: the reverse error (loss of motion) of the linear motion, including the reverse dead zone of the driving parts (such as servo motors, servo hydraulic motors and stepping motors, etc.) on the feed transmission chain of the coordinate axis, each A comprehensive reflection of errors such as backlash and elastic deformation of mechanical motion transmission pairs. The greater the error, the lower the positioning accuracy and repeat positioning accuracy. The detection method of the reverse error is to move a distance in the forward or reverse direction in advance within the stroke of the measured coordinate axis and take this stop position as the reference, and then give a certain movement command value in the same direction to make it move a certain distance. Then move the same distance in the opposite direction and measure the difference between the stop position and the reference position.

Perform multiple measurements (generally 7 times) at three positions close to the midpoint and both ends of the stroke, calculate the average value of each position, and use the largest of the obtained average values ​​as the reverse error value.